Stripper 1080
HumiSeal® Stripper 1080 is:
- compatible with all HumiSeal acrylic coatings.
- compliant with RoHS directive 2015/863/EU
- safe for use on printed circuit board assemblies.
Stripper 1080 has:
- no ozone depleting chemicals
Directions for Use
- immerse the assembly into HumiSeal® Stripper 1080
- soak for 30-60 minutes
- brush loose material from the assembly
- clean the assembly with IPA, DI water or other qualified cleaning solution
- inspect the assembly to ensure the coating has been completely removed
- repeat the steps above if the coating is still on the assembly
- bake for a minimum of 30 minutes @ 60 – 65°C after the final cleaning process
The use of heat is not required for use with HumiSeal® Stripper 1080. A fully cured acrylic coating of nominal thickness will typically dissolve readily within 30 to 60 minutes upon contact with HumiSeal® Stripper 1080. It is important to thoroughly clean the assembly after the conformal coating removal process. Following the cleaning process, the assembly should be baked to remove residual moisture for a minimum of 30 minutes at 60 – 65°C.
Handling Precautions
- Use only in well-ventilated areas.
- Protective gloves and goggles should be worn.
- In case of prolonged skin contact, wash with water.
- In case of eye contact, flush with plenty amount of water and contact physician.
- Avoid prolonged breathing of vapors.
- Unused portions of HumiSeal® products must be disposed of in compliance with all applicable environmental regulations.
- Consult the Safety Data Sheet (SDS) for more specific product information.
| Product Specification | |
| Compatible HumiSeal® Coatings | HumiSeal® Solvent-Based Acrylics |
| Relative Evaporating Rate (BuAc=1) | 1.0 |
| Specific Gravity | 1.3 ± .02 |
| Flash Point (°C) TCC | 21.7 |
| Shelf Life, DOM | 18 months |
| Color | Clear to Reddish |
