Stripper 1072
HumiSeal® Stripper 1072 is:
- it strips all HumiSeal urethane and water-based coatings.
- compliant with RoHS directive 2015/863/EU
- safe for use on printed circuit board assemblies.
Stripper 1072 has:
- flammable ingredients.
Directions for Use
Immerse the component or printed circuit board assembly into HumiSeal® Stripper 1072. The rate at which the existing coating will dissolve will depend upon its thickness and age. Heating HumiSeal® Stripper 1072 will increase its effectiveness (Caution: do not exceed 48°C max). The use of mechanical mixers will speed up the dissolving rate. HumiSeal® Stripper 1072 can also be used to remove the coating from small areas, by applying a few drops to the desired location. After the existing coating has been removed, thoroughly wash the assembly in isopropyl alcohol, deionized water or other qualified cleaning processes. If the component surface of is cloudy after washing, the removal is incomplete. The removal should be repeated for a longer time. Oven dry the assembly for a minimum of 30 minutes at 66°C prior to recoating.
Handling Precautions
HumiSeal® Stripper 1072 is flammable and the following standard safety precautions should be observed:
- Use only in well-ventilated areas.
- Protective gloves and goggles should be worn.
- In case of prolonged skin contact, wash with water. • In case of eye contact, flush with water followed by a diluted boric solution and contact physician.
- avoid prolonged breathing of vapors.
- unused portions of HumiSeal® products must be disposed of in compliance with applicable environmental regulations.
- consult the Material Safety Data Sheet (MSDS/SDS) for more specific product information
| Product Specification | |
| Compatible HumiSeal® Coatings | 1A20, 1A33, 2A64, 1H2O Products |
| Relative Evaporating Rate (BuAc=1) | 0.66 |
| Specific Gravity | 0.99 |
| Flash Point (°C) TCC | 40.6 |
| VOC (grams/litre) | 957 |
| Shelf Life, DOM | 12 months |
| Colour | Blue |
